WebMay 20, 2013 · I changed the gasket between the intake boot and the cylinder. I did a compression test on it and got 120 psi. Up to this point, I have replaced the gaskets between the carb and intake boot, replaced the fuel lines, fuel filter, new fuel tank cap, new air filter, and new spark plug. WebCheck gas tank for fuel level and mix to correct ratio. Set switch to “On”. Set choke lever to “Full”. Press primer bulb 3-4 times (if fitted) Press decompression valve (if fitted) Pull the starter cord sharply. If the starter isn’t pulled sharply and …
13 Reasons a Homelite Chainsaw Won’t Start: SOLVED!
WebJul 7, 2024 · Hook up fuel lines properly. Prime the bulb. If the bulb isn’t pumping fuel properly, it’s more than likely a bad fuel line or the bulb is bad. If it pumps properly, choke it and try to start it. If it doesn’t start, pull plug and see if it’s wet with fuel. If it’s not, there’s probably a blockage in the carb. Jul 5, 2024 · mainstays lightweight iron instructions
Poulan Pro 20" Chainsaw no start - In-Depth Outdoors
WebBy Chris Deziel. When your Stihl 029 chainsaw has just the right combination of air and fuel in its combustion chamber, and the spark plug is firing normally, the saw will hum contentedly while ... WebJul 1, 2009 · So, drain the gas. Pull the spark plug, spin the motor a couple of times, then put it in a safe place and let it sit for a couple of days. (To "dry out"). When you come back, leave the gas tank empty - shoot a bit of starter fluid into it, put the spark plug back in, and see if it fires up. oos.timothy. mainstays lightweight handheld steam iron